AutoTecknic Replacement Glazing Black Fender Gills - BMW E46 M3

Walk up to a parked BMW E46 M3 and the fender gills are right at eye level. Glazing Black is not just a color — it is a finish. A deep, wet-look gloss that reflects light the way factory plastic never could. These AutoTecknic BMW E46 M3 glazing black fender gills use the same OEM clip pattern and dimensional profile as the parts they replace, with a high-gloss finish that holds its look long-term.

Every piece is molded from 100% non-recycled raw ABS plastic, keeping the dimensional accuracy that a proper OEM replacement requires. The retention clips and tabs are built to spec, so the trim seats flush against the fender with no gaps and no float. AutoTecknic individually finishes every unit to achieve that deep gloss tone before it ships. What arrives is ready to install.

Genuine BMW M3 Emblem Option

These gills are available with or without a genuine BMW M3 emblem set. If your current badges are faded, cracked, or missing, adding the emblem set at checkout saves you sourcing them separately. Select your preference before adding to cart.

Key Features

• 100% non-recycled raw ABS plastic for dimensional accuracy and long-term durability
• High-gloss Glazing Black finish for a deep, wet-look appearance
• OEM-spec retention clips and tabs seat flush with no gaps or rattle
• Individually precision-finished before shipping
• Direct OEM replacement, no drilling, cutting, or modification required
• Optional genuine BMW M3 emblem set available at checkout
• Also available in Stealth Black and Prestige Carbon Fiber finishes

What's Included

• 1x driver side fender gill trim
• 1x passenger side fender gill trim
• Genuine BMW M3 emblem set (if selected at checkout)

BMW E46 M3 Fitment

Designed as a direct OEM replacement for the following:

• BMW M3 Coupe / E46 (2001-2006)
• BMW M3 Convertible / E46 (2001-2006)
• BMW M3 CSL / E46 (2003-2004)

Installation Notes

These clip directly into the existing OEM mounting points. A plastic trim pry tool is all you need. Clean the fender recess with isopropyl alcohol before fitting to ensure the clips fully engage on the first press.

1. Carefully pry the existing fender gill trim outward from the front edge to release the retention clips
2. Clean the mounting area with isopropyl alcohol and allow to fully dry
3. Align the replacement trim into the fender recess, lining up all clip tabs with their corresponding holes
4. Press firmly and evenly along the trim length until all clips engage and the piece sits flush
5. If installing emblems, press each badge firmly into its designated mounting point on the gill trim